Dead lift Bar Jack

The Deadlift Bar Jack is assembled and is strong enough to keep even a fully loaded bar off the ground and steady for as long as needed. plastic is also now included to protect the bar’s knurling and finish through repeated uses.

Don’t waste your valuable energy loading and unloading barbells on the ground, save your energy for where it’s needed – Lifting.
Simply slide the jack under your barbell, pivot it back to raise the weights off the ground and then add or remove plates from the barbell effortlessly. Any serious training facility or gym should have one of these effective tools.

Can lift any standard barbell from floor level, allowing easy loading/unloading of weight,Offers a simple and effortless way to lift both sides of the bar at the time. Save your back for the heavy lifting!

Deadlift Bar Jack Super strong steel frame with fully welded joints and centre join secured by  bolts with thick backing plates
product weighs 12.5kg.

The jack is 860mm wide at the barbell supports, 1050mm wide at the base supports, Lever handle is from Ø32mm x 860mm long steel tube
Steel sectional sizes are 50mm x 50mm square ×3mm and Ø32 round x 2.5mm thick tubing.
Nylon wear pads mechanically fixed with countersunk screws on barbell supports protect your barbell knurling.

Dimension: Length  1050mm Width 500mm Height  860mm
Approx 12.5kgs